Model MCC 4X15
Constant Current Wall Mount 4 Charger

The MCC 4X15 is four chargers in one. Built to be wall-mounted above a charging table or bench without the need for a separate charge bar.

Computer controlled electronics provide constant current charging at 15 amps to minimize charging time. Each charger is served by separate, automatic micro-processor controls which (a) regulate current and voltage, (b) provide time control, and (c) automatically sense full state of charge for shut-off.

Charging control is based on constant 15 amps until the battery voltage reaches 16 volts, or full charge, and then a finishing charge at a constant 16 volts for one hour. Minimum charging time is 1 1/2 hours; maximum is 4 hours.

Internal microprocessor diagnostics detect batteries with shorted cells to avoid unsafe charging and wasted customer time.

Better Than Parallel
Traditionally, parallel chargers have been widely used for "back room" charging installations. In many cases, for business reasons, the parallel chargers are not used properly; ie, as "batch" chargers with all batteries starting and finishing together at the same time.
The MCC 4X15 allows batteries to be added or taken off charging as needed with no effect on the other batteries being independently charged.

Safety Features
Each of the four charging units is protected by Reverse Polarity controls for safer service. Shorted cells are detected to avoid excessive heat during charging of defective batteries.

Specifications:

AC Input Power:
Volts AC 120
20 amps AC
60 Hz

DC Output Power:
12 Volts DC (Nominal)
17.0 Volts DC (Max)
15 Amps DC (Max)
(constant current control)

Dimensions:
Heigh:t 10 in.
Width: 12 in.
Depth: 36 in.
Weight: 75 lbs.
(mounts 22 in. above charging table)